Zanussi-Electrolux ZWF1210W User Manual download pdf (Page 24)

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate the

appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance’s inlet and the bottom of

the water storage tank.

Set the hose correctly by loosening the ring nut. After

positioning the inlet hose, be sure to tighten the ring nut

again to prevent leaks.

Water drainage

This appliance is designed to be permanently plumbed

into your home's drainage system using one of the

following methods.

1. Into a drainage standpipe.

Firstly form a hook in the end of the drain hose using

the “U” piece” supplied.

Place the drain hose into your standpipe, which should

have an internal diameter of approximately 38mm thus

ensuring there is an air break between the drain hose

and standpipe.

When discharging into a standpipe ensure that the top of

the standpipe is no more than 90cm (35.4'') and no less

than 60cm (23.6'') above floor level.

P1200

30 cm (12")

38 mm (11.2)

standpipe

diameter

U piece

supplied

P1199

P0021

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece is

available from your local Service Force Centre.

The joining piece must have an internal diameter of

18mm.

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove

any blanking plug that may be in place.

Push the drain hose onto the spigot and secure with a

clip if required, ensure a loop is formed in the drain

hose (see diagram) to prevent waste from the sink

entering the washing machine.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece is

available from your local Service Force Centre.

The joining piece must have an internal diameter of 18mm.

Important

●

Before connecting the machine to new pipework or

to pipework that has not been used for some time,

run off a reasonable amount of water to flush out any

debris that may have collected in the pipes.

●

For the correct functioning of the machine the drain

hose must be hooked on the proper support piece

situated on the top of the back side of the appliance.

P1198

Loop

P1197

P1201

3 pin

Min. 60 cm (23.6)

Max. 90 cm (35.4)

132989470.qxd 26/04/2004 10:54 Pagina 24 (Nero/Process Black pellicola)

1 2 ... 19 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments

Zanussi-Electrolux ZWF1210W User Manual Page 24

Comments to this Manuals

Related products and manuals for Washing machines Zanussi-Electrolux ZWF1210W