Zanussi-Electrolux ZEBF290SI User Manual download pdf (Page 10)

MAINTENANCE AND CLEANING

External cleaning

Many proprietary kitchen surface cleaners

contain chemicals that can attack/damage the

plastics used in this appliance. For this reason it

is recommended that the outer casing of this

appliance is only cleaned with warm water with a

little washing-up liquid added.

An accumulation of dust will affect the performance

of the appliance and cause excessive electricity

consumption.

You MUST ensure that the appliance is switched

OFF.

Once or twice a year dust the condenser (black grill)

and the compressor at the back of the appliance,

with a brush or vacuum cleaner, see figure.

PR259

Before any maintenance or cleaning work is carried

out, DISCONNECT the appliance from the

ELECTRICITY supply.

Internal cleaning

Clean the inside and accessories with warm water

and bicarbonate of soda (5ml to 0.5 litre of water).

Rinse and dry thoroughly.

NEVER USE DETERGENTS, ABRASIVE

POWDERS, HIGHLY PERFUMED

CLEANING PRODUCTS OR WAX

POLISHES, TO CLEAN THE INTERIOR AS

THESE WILL DAMAGE THE SURFACE AND

LEAVE A STRONG ODOUR.

Changing the light bulb

Should the interior light fail to work, first switch off

the appliance and disconnect from the electricity

supply, then replace the bulb as follows;

Unscrew the light cover and then pull it outward by

pressing as shown in the figure. Unscrew the bulb

and replace it with a new 15 watt bulb (available from

your nearest Service Force Centre).

Replace the light cover by sliding it into its original

position and replace the security screw.

D613

When the appliance is not in use

When the appliance is not in use for long periods,

disconnect from the electricity supply, empty all

foods and clean the appliance, leaving the doors ajar

to prevent unpleasant smells.

Automatic Defrosting

Your appliance has been designed to be frost free.

This means there is no need to defrost your

appliance as this will be carried out automatically.

SOMETHING NOT WORKING

Before contacting your local Service Force Centre, check the following points:

Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or

installation a charge will be made, even if the appliance is under guarantee.

If, after the above checks, there is still a fault, call your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a

charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

Symptom

No power to the appliance

The light does not come on

The temperature in the fridge or freezer section is

too high

The freezer door will not open

The compressor runs continously

Noise

Solution

Check there is power at the socket.

Check there is not a power cut by checking the

household lights.

Check the fuse has not blown.

Ensure that the bulb is correctly fitted.

Replace the bulb if it has blown.

Check the door light switch is not jammed.

Check the termostat control knob on the top panel is

turned to the correct setting relative to ambient

conditions.

Check the ambient temperature is within the

appliance’s operating limits, please refer to the

installation section in this instruction book.

Relocate the appliance if necessary.

Has door just been opened? If so leave for a few

minutes to allow the air pressure to equalise.

Adjust the thermostat control knob to give correct

temperature control. See “Setting the temperature”.

Check that the doors are closed.

Large quantities of food have recently been placed in

the cabinet and/or door is frequently opened.

Check that air vents is not obstructed.

Refer to normal operating sounds.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Zanussi-Electrolux ZEBF290SI User Manual Page 10

Comments to this Manuals

Related products and manuals for Fridges Zanussi-Electrolux ZEBF290SI