Zanussi-Electrolux ZEBF290SI User Manual download pdf (Page 6)

Warning

If using the appliance with the salad drawer

removed, please ensure the vent in the back wall of

the appliance is not obstructed.

D756

Positioning the inner shelves

The walls of the refrigerator have runners so that

shelves can be positioned as desired.

For better use of space, the front half-shelves can lie

over the rear ones.

D338

Positioning the door shelves

The door shelves can be easily removed for

cleaning. Gently ease the shelf in the directions

shown.

Adjustment of the door shelves can be made to

accommodate varying heights of bottles and other

containers. Store light items such as small cartons

and jars on the door shelves. The bottle shelf can be

used for the storage of heavier bottles.

PR260

INSTALLATION

Positioning

This appliance should only be installed at a location

where the ambient temperature corresponds to the

climate classification indicated on the rating plate,

which is located at the left on the inside of the

appliance.

The following table shows which ambient temperature

is correct for each climate classification:

SN +10°C to + 32°C

N +16°C to + 32°C

ST +18°C to + 38°C

T +18°C to + 43°C

It should be located in a dry atmosphere, out of direct

sunlight and away from extreme temperature e.g. not

next to a boiler or radiator, or in a very cold room e.g.

an outhouse, where the temperatures may fall below

10°C (50°F). If these temperatures are exceeded i.e.

colder or warmer, then the appliance may not operate

correctly.

You should also ensure that air can circulate freely

around the back and the top of the cabinet. There

must also be at least 100 mm (4”) distance between

the top of the cabinet and any overhanging kitchen

furniture (A). Ideally, the appliance should not be

positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of

the appliance. Do not obstruct the space underneath.

Rear spacers

The plastic bag containing all relevant documentation

also contains two spacers to be fitted into special

holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in the

diagram. Then turn them through 45° (arrow (A)

vertical) until they lock into place.

DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the

adjustable foot, or feet, at the bottom of the cabinet

using your fingers or a tool (see figure).

D200

NP00

100 mm10 mm

10 mm

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.

Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on “Door reversal directions” paragraph.

PR60

45°

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Zanussi-Electrolux ZEBF290SI User Manual Page 6

Comments to this Manuals

Related products and manuals for Fridges Zanussi-Electrolux ZEBF290SI