Zanussi-Electrolux CZC16/9FA User Manual download pdf (Page 4)

OPERATION

Before using

Remove all securing tapes. Wash inside the

appliance with lukewarm water and bicarbonate of

soda (5 ml to 0.5 litre of water).

Do not use soap or detergent as the smell may

linger. Dry thoroughly.

Setting the temperature

The temperature inside the appliance is regulated by

a thermostat with 6 temperature positions and an

“OFF” (

●) position.

Position 1 = minimum coldness

Position 6 = maximum coldness

Turn the thermostat control knob to the required

position.

The intermediate position is usually the most

suitable (3-4).

The thermostat control knob regulates the

temperature both within the fridge and the freezer

compartment. The thermostat setting can vary as the

temperature inside the appliance depends on the

following factors:

– room temperature

– how often the door is opened

– how much food is stored

– position of the appliance

To Start the Appliance

Allow the appliance to stand for 2 hours after

installation.

Plug in the appliance and switch on at the mains

supply. Turn the thermostat control (B) to a midway

setting (3-4) and adjust the slider control, situated on

the back wall of the fridge section, to a midway

position between “MIN” and “MAX”. The pilot light (A)

will illuminate. Leave the appliance for approximately

4 hours for the correct temperature to be reached

before placing food inside.

To switch off the appliance turn the thermostat

control to position “

●”

Control panel

A - Pilot light

B - Thermostat control knob

Use of an air circulation slider

control - COOL FLOW CONTROL

Your appliance has an air circulation slider control

situated at the rear of the fridge compartment, which

controls the amount of cold air circulated through the

fridge compartment.

When the ambient temperature is between 10°C and

16°C, the slider control should be in the “MIN”

position.

When the ambient temperature is above 16°C the

slider control should be midway between “MIN” and

“MAX”.

When the ambient temperature is very high (i.e. hot

summer days) position the slider control to “MAX”.

D757/1

MIN

MAX

COOL FLOW CONTROL

MIN MAX

COOL FLOW CONTROL

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Zanussi-Electrolux CZC16/9FA User Manual Page 4

Comments to this Manuals

Related products and manuals for Fridges Zanussi-Electrolux CZC16/9FA